Use the Wake-on-LAN option in RemotePC to wake up an offline computer and establish a remote connection.
Ensure the following settings and hardware requirements are fulfilled before using the Wake-on-LAN option:
After ensuring that our computer meets the above requirements, you can proceed with configuring your Windows machines for WOL.
Set up Windows
To wake up a computer via WoL, you should enable WoL in BIOS settings and configure the network card.
To enable WoL in BIOS settings,
Note: If there is no option to enable Wake-on-LAN in BIOS setup, refer to the motherboard manual to ensure your computer supports Wake-on-LAN.
Configure Network Card
The network card must be configured in such a way that the power is supplied all the time.
To configure network card,
Note: The configuration steps may vary depending on the network card and operating system.
Configure Windows 8
In Windows 8 OS the standard shutdown procedure puts the computer into the hybrid shutdown state, as Windows 8 does not support Wake-on-LAN for this state. Hence we recommend you deactivate the fast startup. Once fast startup is deactivated, the computer will always go into hibernate mode during shut down.
To deactivate the fast startup,